CIS CHEM HSR 1 3 5 i s a new gene r a ti on
superplasticizer based on polycarboxylic ether along
with advanced technology. It allows concrete to
achieve stable workability for long duration is
especially for concrete big job site area where require
high workability retention without affecting early and
long term strength
CIS CHEM HSR 135 facilitates good water reduction,
with optimum cohesion and workability as required,
just by adjusting the dosage. It is used mainly to the
following types of concrete:
CIS CHEM HSR 135 acts by surface absorption on the cement particles producing sterical
hindrance as well as
electrostatic repulsion between cement particles which results in higher dispersion, flow
and retention. CIS
CHEM HSR 135 provides the following beneficial properties:
Composition |
Modified Naphthalene Formaldehyde Sulphonate |
Packaging |
250 KG |
Appearance / Colour |
Light brown to brown liquid |
Shelf life |
12 months from date of production if stored properly |
Storage conditions |
Store in undamaged, unopened, original sealed packaging in dry
conditions at temperatures between +5 °C and +45 °C. Protect
from direct sunlight and frost |
Density |
1.20 ± 0.05 kg/l at 30 0C |
Total chloride ion content |
Nil (EN 934-2) |
Concreting guidance |
The standard rules of good concreting practice for production
and placing must be observed when using CIS CHEM FLOW 110
in concrete. Refer to relevant standards.
Fresh concrete must be cured properly especially at high
temperatures in order to prevent plastic and drying |
Recommended dosage |
0.4 - 2.0 % by weight of binder
Higher dosages by weight of binder can be used depending on
the mix design, raw materials, climatic conditions and concrete
requirements. Trial mixes must be performed to establish the
exact dosage rate required. |
Compatibility |
CIS CHEM FLOW 110 may be combined with all types of Portland
cement We recommend to perform trial mixes to establish the
required performance when combined with the above products.
Please consult our CIS Technical Department. |
CIS CHEM FlOW 110 should not be swallowed or allowed
to come into contact with skin and eyes.
Suitable protective gloves and goggles should be worn. Splashes on the skin should be
removed with
water. In case of contact with eyes it shall be rinsed immediatewith plenty of water and
medical advice
sought immediately. If swallowed, medical attention shall be sought immediately.
Vomiting should not
be used.